Output not displayed

Hi there ! I was trying to use the ‘‘show collections’’ and the command executes fine but there is no output of the command. Can anyone please suggest me what might be causing this ??

Also, compass is not working and crashing

Hi,

for show collections make sure you have used the ‘use …database’ name first and it should say switched to … then show collections should work. Also the case does matter. I.e. spell the upper or lower case exactly. It does not complain if you spell it wrong and still says using the incorrectly spelled database. Hope this helps.

Thanks,
Ashok

Hi there ! I was trying to use the ‘‘show collections’’ and the command executes fine but there is no output of the command. Command was written in lower case and use database was also executed before.Can anyone please suggest me what might be causing this ??

Only one reason can be there that I can think of is the database name is misspelled by any chance.

Please check again and maybe you can share the screenshot as well. Test it on Compass as well.

Kanika